Torque
CWST-JT-TG Series Torque Sensors
Introduction
1．Measurement and control for non-continuous rotation torque force value, the maximum deflection angle: ≯360 degrees
2. Measurement of static torque
3． Measurement of both static torque and dynamic torque
4. High precision, good stability
5. Small size, light weight, easy installation
6. Need no zero repetition to continuously measure the positive and negative torques
7. Strong elastomer measuring ability, can withstand 100% overload;
8. Strong anti-interference ability
load, then adjust the prime mover and the load axis with respect to distance from the reference plane. Their axes’ coaxial is less than Φ 0.03mm, and concentricity shall not exceed 0.1mm. Fix the prime mover and the load on the plane.
2. Put the couplings into their respective axes.
3. Adjust the distance between the torque sensor and the reference plane, make sure the prime mover and load’s coaxial is less than Φ 0.03mm, then fix the torque sensor to the plane.
4. Tighten couplings to complete installation.
Installation Precautions and Maintenance
1. When in installation, don’t live action, direct beat and crash sensors.
2. Coupling fastening bolts should be tightened, outside coupling shield should be added, avoid personal injury.
3. Power and load equipment must be fixed to avoid vibration
4. The base of the sensor and device should be fixed (can swing) as flexible as possible, to avoid bending moments.
5. Operation environment: torque sensor should be installed in an ambient temperature of 0 ℃ ~ 60 ℃, relative humidity less than 90%
6. Non-flammable, explosive materials environment.
7. Should not be installed in the environment of strong electromagnetic interference.
8. Should grease both ends of the torque sensor bearing every other year. When greasing, only open the ends of the bearing cover, add grease to the bearing, and then cover both ends.
9. Should be stored in a dry, non-corrosive, room temperature -20 ℃ --70 ℃ environment.
